In the manufacturing process of the electronic industry, every small detail will have a great impact and harm on electronic components. Especially the air humidity of the workshop production environment, if the workshop environment is in the production and processing process of some precision electronic parts or products, the workshop environment If the humidity is not up to standard or too low, it is easy to generate static electricity. The generation of a large amount of static electricity is bound to cause many adverse effects and hazards to precision electronic components. Therefore, any electronic factory must not only conduct workshops, warehouses, etc. The relative humidity of the environment should be strictly controlled, and anti-static work should be done well.
Relevant tests show that when the relative humidity is lower than 40% RH, it is easy to generate static electricity; when the relative humidity reaches 30% RH, the electrostatic voltage can reach 5000V; when the relative humidity is as low as 20% RH, it will be Generate electrostatic voltage up to 10000V; because the workshop humidity is not up to standard or too low, many electronic factories produce products that fail to meet the standard, and defective or scrapped products increase, and even forced to stop work!
Electrostatic discharge is the main cause of breakdown hazards of electronic components and interference with the operation of electronic equipment. In the production of electronic products, from component pretreatment, installation, welding, cleaning, to single board testing, total testing, Until packaging, storage, delivery and other processes, it may cause electrostatic discharge breakdown hazards to the device.
Gezhi industrial anti-static series dehumidification cabinet, the cabinet is made of permanent anti-static baking paint, which is scratch-resistant and prevents the phenomenon of electronic penetration caused by static electricity generated by low humidity, and is equipped with anti-static casters and conductive grounding wires to ensure overall anti-static. The conductivity coefficient of the coating of the dehumidification cabinet is 10, which is in line with national and industry ESD standards such as SJ\/T10694-2006 (General Specification for Anti-static for Electronic Product Manufacturing and Application Systems). Complete and reliable anti-static protection system, and permanent use, no Micro pollution. It is especially recommended for the storage of various integrated circuits such as IC, BGA, QFP, etc. after opening, to prevent and avoid PCB delamination failure, LED brackets, chips and other semi-finished products due to electrostatic damage.
